Hunter Pump Start Relay Wiring Diagram. Wiring A Pump Start Relay Install Pump Start Relay cover plate and four screws The pump motor wires from a 220 volt 1 1/2 HP sprinkler pump are both black wires and are on the right side of the relay.
PSR22 Pump Start Relay for Sprinkler & Irritation Systems from www.sprinklerwarehouse.com
troller to the other yellow wire on the Pump Start Relay A pump start relay is a device that uses a signal from the controller to actuate a separate electrical circuit to energize a pump to provide water to your system
PSR22 Pump Start Relay for Sprinkler & Irritation Systems
The controller should be mounted at least a 15 ft (4.5 m) away from both the pump start relay and pump to minimize any potential electrical interference. The yellow wires are attached to 24v side of controller NOTE: Complete this section only if you have a pump start relay installed
Hunter Pump Start Relay PSR22 loud noises Wired Flow Sensors. Power wires from the power source and to the pump should be 12 AWG with a temperature rating of 55⁰ troller to the other yellow wire on the Pump Start Relay
Pump Start Relay Wiring Diagram. This pump requires a special relay switch -- such as the Hunter PSR-22 -- that you must properly wire into the sprinkler system's controller before it will operate correctly The controller should be mounted at least a 15 ft (4.5 m) away from both the pump start relay and pump to minimize any potential electrical interference.